A set of servers is used for an FTP application as well as an HTTP website via separate BIG-IP Pools. The server support team reports that some servers are receiving a lot more traffic than others. Which Load Balancing Method should the BIG-IP Administrator apply to even out the connection count?

• A. Ratio (Node)
• B. Least Connections (Node)
• C. Ratio (Member)
• D. Least Connections (Member)

A BIG-IP Administrator configured a virtual server with a pool of 3 members and selected the Round Robin load balancing method to evenly distribute traffic across the pool members. During initial testing, the virtual server failed to respond to http requests.
Plaintext
ltm virtual http.vs {
destination 10.10.1.100:http
ip-protocol tcp
mask 255.255.255.255
pool http.pool
profiles {
tcp{}
}
serverssl-use-sni disabled
source 0.0.0.0/0
translate-address enabled
translate-port enabled
}
ltm pool http_pool {
members {
10.10.1.101:http {
address 10.10.1.101
session monitor-enabled
state checking
}
10.10.1.102:http {
address 10.10.1.102
session monitor-enabled
state checking
}
}
monitor tcp
}
What configuration change on the BIG-IP will resolve this issue?

• A. Add http monitor
• B. Add SNAT Auto Map
• C. Add http profile

Some users who connect to a busy Virtual Server have connections reset by the BIG-IP system.
Pool member resources are NOT a factor in this behavior. What is a possible cause for this behavior?

• A. The server SSL Profile has NOT been reconfigured.
• B. The Connection Limit is set too low.
• C. The Rewrite Profile has NOT been configured.
• D. The Connection Rate Limit is set too high

A BIG-IP Administrator is receiving intermittent reports from users that SSL connections to the BIG-IP device are failing. Upon checking the log files, the administrator notices: SSL transaction (TPS) rate limit reached. Reviewing stats shows a max of 1200 client-side SSL TPS and 800 server-side SSL TPS. What is the minimum SSL license limit capacity required to handle this peak?

• A. 400
• B. 800
• C. 2000
• D. 1200