[Jun 09, 2024] New NSE5_FMG-7.0 Exam Dumps with High Passing Rate
Get NSE5_FMG-7.0 Braindumps & NSE5_FMG-7.0 Real Exam Questions
NEW QUESTION # 34
What are two outcomes of ADOM revisions? (Choose two.)
- A. ADOM revisions can save the current size of the whole ADOM
- B. ADOM revisions can create System Checkpoints for the FortiManager configuration
- C. ADOM revisions can save the current state of all policy packages and objects for an ADOM
- D. ADOM revisions can significantly increase the size of the configuration backups.
Answer: C,D
NEW QUESTION # 35
Refer to the following exhibit:
Which of the following statements are true based on this configuration? (Choose two.)
- A. The same administrator can lock more than one ADOM at the same time
- B. Unlocking an ADOM will install configuration automatically on managed devices
- C. Unlocking an ADOM will submit configuration changes automatically to the approval administrator
- D. Ungraceful closed sessions will keep the ADOM in a locked state until the administrator session times out
Answer: A,D
NEW QUESTION # 36
When an installation is performed from FortiManager, what is the recovery logic used between FortiManager and FortiGate for an FGFM tunnel?
- A. FortiGate will reject the CLI commands that will cause the tunnel to go down.
- B. After 15 minutes, FortiGate will unset all CLI commands that were part of the installation that caused the tunnel to go down.
- C. FortiManager will revert and install a previous configuration revision on the managed FortiGate.
- D. FortiManager will not push the CLI commands as a part of the installation that will cause the tunnel to go down.
Answer: B
NEW QUESTION # 37
Which of the following statements are true regarding VPN Gateway configuration in VPN Manager? (Choose two.)
- A. External gateways are third-party VPN gateway devices only
- B. Protected subnets are the subnets behind the device that you don't want to allow access to over the IPsec VPN
- C. Managed devices in other ADOMs must be treated as external gateways
- D. Managed gateways are devices managed by FortiManager in the same ADOM
Answer: C,D
NEW QUESTION # 38
What does a policy package status of Conflict indicate?
- A. The policy package configuration has been changed on both FortiManager and the managed device independently.
- B. The policy package reports inconsistencies and conflicts during a Policy Consistency Check.
- C. The policy package does not have a FortiGate as the installation target.
- D. The policy configuration has never been imported after a device was registered on FortiManager.
Answer: A
NEW QUESTION # 39
An administrator has assigned a global policy package to a new ADOM called ADOM1. What will happen if the administrator tries to create a new policy package in ADOM1?
- A. When a new policy package is created, the administrator must assign the global policy package from the global ADOM.
- B. When the new policy package is created, FortiManager automatically assigns the global policy package to the new policy package.
- C. When a new policy package is created, the administrator needs to reapply the global policy package to
ADOM1. - D. When creating a new policy package, the administrator can select the option to assign the global policy
package to the new policy package
Answer: B
NEW QUESTION # 40
In addition to the default ADOMs, an administrator has created a new ADOM named Training for FortiGate devices. The administrator sent a device registration to FortiManager from a remote FortiGate. Which one of the following statements is true?
- A. The FortiGate will be added automatically to the default ADOM named FortiGate.
- B. By default, the unregistered FortiGate will appear in the root ADOM.
- C. The FortiGate will be automatically added to the Training ADOM.
- D. The FortiManager administrator must add the unregistered device manually to the unregistered device
Answer: B
Explanation:
manually to the Training ADOM using the Add Device wizard
NEW QUESTION # 41
View the following exhibit.
Which one of the following statements is true regarding the object named ALL?
- A. FortiManager installed the object ALL with the updated value.
- B. FortiManager updated the object ALL using FortiManager's value in its database
- C. FortiManager created the object ALL as a unique entity in its database, which can be only used by this managed FortiGate.
- D. FortiManager updated the object ALL using FortiGate's value in its database
Answer: D
NEW QUESTION # 42
When an installation is performed from FortiManager, what is the recovery logic used between FortiManager and FortiGate for an FGFM tunnel?
- A. FortiGate will reject the CLI commands that will cause the tunnel to go down.
- B. After 15 minutes, FortiGate will unset all CLI commands that were part of the installation that caused the tunnel to go down.
- C. FortiManager will revert and install a previous configuration revision on the managed FortiGate.
- D. FortiManager will not push the CLI commands as a part of the installation that will cause the tunnel to go down.
Answer: B
Explanation:
The configuration change will break the fgfm connection, causing the FortiGate unit to attempt to reconnect for 900 seconds. If the FortiGate cannot reconnect, it will rollback to its previous configuration.
NEW QUESTION # 43
What is the purpose of ADOM revisions?
- A. To create System Checkpoints for the FortiManager configuration.
- B. To save the current state of all policy packages and objects for an ADOM.
- C. To save the current state of the whole ADOM.
- D. To revert individual policy packages and device-level settings for a managed FortiGate by reverting to a specific ADOM revision
Answer: B
Explanation:
Fortimanager 6.4 Study guide page 198
NEW QUESTION # 44
An administrator, Trainer, who is assigned the Super_User profile, is trying to approve a workflow session that was submitted by another administrator, Student. However, Trainer is unable to approve the workflow session.
What can prevent an admin account that has Super_User rights over the device from approving a workflow session?
- A. Trainer is not a part of workflow approval group
- B. Student, who submitted the workflow session, must first self-approve the request
- C. Trainer does not have full rights over this ADOM
- D. Trainer must close Student's workflow session before approving the request
Answer: A
NEW QUESTION # 45
Which of the following statements are true regarding reverting to previous revision version from the revision history? (Choose two.)
- A. To push these changes to a managed device, it required an install operation to the managed FortiGate.
- B. It will modify device-level database
- C. Reverting to a previous revision history will tag the device settings status as Auto-Update.
- D. Reverting to a previous revision history will generate a new version ID and remove all other history
Answer: A,B
NEW QUESTION # 46
An administrator would like to create an SD-WAN using central management in the Training ADOM.
To create an SD-WAN using central management, which two steps must be completed? (Choose two.)
- A. Remove all the interface references such as routes or policies that will be a part of SD-WAN member interfaces
- B. Specify a gateway address when you create a default SD-WAN static route
- C. Enable SD-WAN central management in the Training ADOM
- D. Configure and install the SD-WAN firewall policy and SD-WAN static route before installing the SD-WAN template settings
Answer: A,C
NEW QUESTION # 47
What will happen if FortiAnalyzer features are enabled on FortiManager?
- A. FortiManager will keep all the logs and reports on the FortiManager.
- B. FortiManager will enable ADOMs to collect logs automatically from non-FortiGate devices.
- C. FortiManager can be used only as a logging device.
- D. FortiManager will install the logging configuration to the managed devices
Answer: D
NEW QUESTION # 48
View the following exhibit, which shows the Download Import Report:
Why it is failing to import firewall policy ID 2?
- A. Policy ID 2 is configured from interface any to port6 FortiManager rejects to import this policy because any interface does not exist on FortiManager
- B. The address object used in policy ID 2 already exist in ADON database with any as interface association and conflicts with address object interface association locally on the FortiGate
- C. Policy ID 2 does not have ADOM Interface mapping configured on FortiManager
- D. Policy ID 2 for this managed FortiGate already exists on FortiManager in policy package named Remote-FortiGate.
Answer: B
Explanation:
FortiManager_6.4_Study_Guide-Online - page 331 & 332
NEW QUESTION # 49
Refer to the exhibit.
A junior administrator is troubleshooting a FortiManager connectivity issue that rs occurring with managed FortiGate devices Given the FortiManager device manager settings shown in the exhibit what can you conclude from the exhibit?
- A. The administrator must refresh both devices to restore connectivity
- B. The administrator can reclaim the FGFM tunnel to get both devices online
- C. The administrator had restored the FortiManager configuration file
- D. FortiManager test internet connectivity therefore, both devices appear to be down
Answer: D
NEW QUESTION # 50
Which two items does an FGFM keepalive message include? (Choose two.)
- A. FortiGate uptime
- B. FortiGate configuration checksum
- C. FortiGate IPS version
- D. FortiGate license information
Answer: B,C
NEW QUESTION # 51
Refer to the exhibit.
Which two statements are true if the script is executed using the Device Database option? (Choose two.)
- A. The script history will show successful installation of the script on the remote FortiGate
- B. The successful execution of a script on the Device Database will create a new revision history
- C. The Device Settings Status will be tagged as Modified
- D. You must install these changes using the Install Wizard to a managed device
Answer: C,D
NEW QUESTION # 52
View the following exhibit.
What is the purpose of setting ADOM Mode to Advanced?
- A. This setting allows you to assign different VDOMs from the same FortiGate to different ADOMs.
- B. The setting enables the ADOMs feature on FortiManager
- C. The setting allows automatic updates to the policy package configuration for a managed device
- D. The setting disables concurrent ADOM access and adds ADOM locking
Answer: A
NEW QUESTION # 53
Refer to the exhibit.
An administrator has created a firewall address object, Training which is used in the Local-FortiGate policy package.
When the installation operation is performed, which IP/Netmask will be installed on the Local-FortiGate, for the Training firewall address object?
- A. Local-FortiGate will automatically choose an IP/Netmask based on its network interface settings.
- B. 10.200.1.0/24
- C. 192.168.0.1/24
- D. It will create a firewall address group on Local-FortiGate with 192.168.0.1/24 and 10.0.1.0/24 object values.
Answer: B
Explanation:
FortiManager_6.4_Study_Guide-Online - page 209
In the example, the dynamic address object LocalLan refers to the internal network address of the managed firewalls. The object has a default value of 192.168.1.0/24. The mapping rules are defined per device. For Remote-FortiGate, the address object LocalLan referes to 10.10.11.0/24. The devices in the ADOM that do not have dynamic mapping for LocalLan have a default value of 192.168.1.0/2.
NEW QUESTION # 54
What does the diagnose dvm check-integrity command do? (Choose two.)
- A. Internally upgrades existing ADOMs to the same ADON version in order to clean up and correct the ADOM
syntax - B. Verifies and corrects database schemas in all object tables
- C. Verifies and corrects duplicate VDOM entries
- D. Verifies and corrects unregistered, registered, and deleted device states
Answer: C,D
Explanation:
6.2 Study Guide page 305 verify and correct parts of the device manager databases, including: - inconsistent device-to-group and group-to-ADOM memberships - unregistered, registered, and deleted device states - device lock statuses - duplicate VDOM entries
NEW QUESTION # 55
......
NSE5_FMG-7.0 Dumps To Pass Fortinet Exam in 24 Hours - Actual4dump: https://whizlabs.actual4dump.com/Fortinet/NSE5_FMG-7.0-actualtests-dumps.html